This is what ought to be done to safely work with a wood heating system. Before you ever take up a fire in your wood heater check the stove pipe and chimney. Turn to see they are properly connected and that they have no holes showing. Fumes like carbon monoxide, and smoke, could escape into your house through a hole in the stove pipe, as could flames f you ever have a small chimney fire. That could take up a house fire.
Open a window some to permit oxygen from outside to enter the area where your heater is burning. The fire burns up the oxygen present in the room when the heater is operating.
It is a good notion to possess your heater sitting on a sheet metal base, that stretches out while watching heater's door. This metal sheet spreads out any excessive heat on to the floor and really should the fire spit out burning embers when the door is opened for putting wood in, the floor will be protected from burns. This can often happen if the wood being burnt isn't completely dry. Some forms of wood like spruce will tend to pop and spit embers frequently while burning.
Check the fire proof chord seal around the door of the heater, making sure that you can find no holes or gaps present. You want the fire box of one's heater air tight once you close the draft lever shutting off the ventilation. The draft lever lets you control how hot the fire burns. Closing the draft lever decreases the fire by stopping its oxygen supply.
You need to keep a door seal repair kit on hand. It contains a tube of liquid adhesive and a length of fire proof rope-like chord. If you can start to see the light of the fire through the edge of the door where in fact the door seal is situated, repair is needed.
It is best to do the repair once the door of the heater is still quite warm. Measure and cut the correct length of door sealing chord that may fit all over the door in the groove. Scrape out the old chord still inside the heater door groove and when clean wipe it with a rag. Apply the liquid adhesive several drops at a time to the within of the groove. The heat of the door may cause it to become sticky in a few minutes. When the adhesive becomes gel-like, press the chord into the groove with a screwdriver. Hold the chord in place for a couple moments while it sets, attaching a few inches of the chord to the groove at the same time. When it's all set up, close the heater door. Tighten the door latch whenever you can and let it set for about fifteen minutes.
The chimney must be checked for an excess of soot deposited on its inside. This can be a good notion to open the hole for the soot to fall down the chimney and stove pipe into the heaters burning chamber. This is done by turning two fire bricks on their side near the top of the heaters burning chamber.
Wear old clothes. Take hand wiping rag, chimney cleaning brush, and the tools needed to take away the stove pipe cap near the top of your chimney. Carefully climb onto the roof. Remove the chimney cap and brush the soot off the within of the cap. Look inside the chimney. You'll likely see a layer of black soot covering the the surface of the chimney. Blow it away. Take the chimney brush and carefully push it down and pull it up the chimney. Do that repeatedly until you see forget about black near the top of the chimney. If it is clean reattach the cap onto the chimney, clean your hands and tools with the rag and become careful climbing down off the roof. Invest some time. https;//outdoors.com isn't worth getting hurt by falling.
Wood heat is a comfortable method of heating your home but it does take some safety knowledge and precautions to take action safely.